# How to dry swing-top bottles

Learn how to dry swing-top bottles after washing, keep the gasket free of moisture and store bottles so mold does not grow between batches of drinks.

How to dry swing-top bottles comes down to moving air and an open lid, so water cannot sit in the gasket or the base of the bottle. After washing, empty each bottle fully, prop it upside down on a rack and leave the wire closure flipped open until the inside is dry. The steps below cover air drying, checking the gasket for trapped moisture and storing the bottles so they stay clean. 

## Open the lid before drying 

A swing-top bottle traps water where the lid meets the neck, so flip the wire closure open before you put the bottle to dry. The rubber gasket, the soft ring inside the cap, holds a thin film of moisture against the glass. Leave the cap hanging clear of the opening so air reaches that ring on every side. With the lid open, the bottle also drains through the neck instead of collecting water at the rim. 

## Set bottles upside down on a rack 

Air drying works when water can run out of the bottle and air can move through the neck. Stand each bottle mouth-down on a drying rack or a draining peg so the last drops fall away from the base. Space the bottles apart so air circulates between them rather than trapping damp air in a tight cluster. A warm, ventilated spot dries a bottle faster than a cold corner, and a towel laid flat holds moisture underneath. 

## Store dry bottles with lids open 

Mold prevention starts with putting bottles away only when they are fully dry inside. Leave the closure flipped open in storage, because a closed lid seals damp air into a bottle that looked dry at the neck. Check the gasket before each fill, since a gasket that stays wet can grow mold and pass it to your drink. Store the bottles somewhere dry and dust-free until the next round of drinks. 

## Questions about drying swing-top bottles 

### Should the lid be open or closed while a swing-top bottle dries? 

The lid should stay open while a swing-top bottle dries. An open lid lets air reach the gasket and lets water drain freely from the neck. Closing the lid during drying traps moisture against the rubber ring and slows the whole process. Flip the closure shut only when the bottle is completely dry and ready to store or fill. 

### How do I keep moisture out of the gasket? 

Moisture leaves the gasket when the cap hangs open and air passes over the rubber ring. Shake the bottle out after rinsing so water does not pool at the cap, then set it mouth-down with the lid clear. Wipe the gasket with a clean cloth if you see droplets clinging to it. A dry gasket keeps the seal clean and stops mold from forming in the closure. 

### Do swing-top bottles need a drying rack? 

A drying rack helps a swing-top bottle dry because it holds the bottle upside down and lets air pass underneath. Any rack with upright pegs or a wire frame that grips the neck will do the job. Without a rack, a bottle set on its side keeps water against the glass and the gasket. The rack only needs to keep the mouth lower than the base so water runs out. 

### Can I dry swing-top bottles with a towel? 

A towel is not enough to dry the inside of a swing-top bottle, so air drying finishes the job. A cloth pushed inside cannot reach the shoulder and base evenly and can leave lint behind. Use a towel only to wipe the outside and the gasket, then let the inside air dry on a rack. Bottles put away damp grow mold, which spoils the next drink you pour.
