# How to build a cocktail smoker and smoking board

A practical guide to building your own cocktail smoker and smoking board at home, from the smoke chamber and torch to wood chips and safe handling.

Building a cocktail smoker and smoking board means making two simple pieces of gear: a chamber that traps smoke over a glass and a board that holds the glass while you work. You can make a DIY smoke infuser from a few household parts instead of buying a cocktail smoker kit, then pair it with a wooden board. The page explains each part, the tools that burn the wood chips safely, and how to put the pieces together for smoke infusion at home. 

## Making the smoke chamber 

A cocktail smoker works by trapping smoke in a small chamber placed over the glass, so the drink picks up aroma before you lift it. A homemade smoke infuser can be as simple as a jar or a small inverted bowl with a hole cut in the top for the smoke. The chamber must sit flat on the rim so smoke does not escape sideways, and a clear glass or plastic version lets you watch the smoke settle. Cut edges need smoothing so no splinters fall into the drink. 

## Building the smoking board 

A smoking board is the wooden base that holds your glass steady while you place the chamber and apply the torch. Choose a solid wood board with enough surface to sit the glass and a small dish of wood chips beside it, away from the drink. Drill a shallow recess for the glass foot so the board does not slide during use, and sand every surface smooth. Untreated hardwood suits a smoking board because it resists scorching better than soft resinous timber. 

## Smoke, torch and wood chips 

Smoke comes from wood chips heated until they smolder, not from a flame held over the drink. A small kitchen torch or a handheld smoker gun gives you control over where the heat goes, and you light the chips in a metal dish on the board. Keep the flame moving and stop once the chips glow, because a long burn turns the aroma harsh and bitter. Never leave a lit torch or smoldering chips unattended, and keep a damp cloth nearby. 

## Questions about building a cocktail smoker 

### How do you build a cocktail smoker board? 

A cocktail smoker board is built from one flat hardwood board with a shallow recess for the glass and a clear space for a metal chip dish. Sand the board smooth, cut the recess to match the base of your glass, and keep the chip area away from the drink. Finish the wood with a food-safe oil so spills wipe away easily. The board only holds the gear steady, so the smoker chamber still does the work of trapping smoke. 

### Can you make your own cocktail smoker without a kit? 

Yes, you can make your own cocktail smoker from a jar, a small bowl or a length of wide tubing with a hole in the top. The homemade version needs a flat rim that seals against the glass and a hole wide enough to pass smoke from the burning chips. A cocktail smoker kit simply supplies these parts cut to size, so a DIY build trades convenience for assembly work. Check that every material you use is heat-resistant before you bring a torch near it. 

### What do you need for a DIY smoke infuser? 

A DIY smoke infuser needs a chamber that fits over the glass, a metal dish for the wood chips, and a heat source such as a small torch. You also need a wooden board to protect the surface beneath and a lid or cover to hold the smoke in place. Wood chips should be untreated and sold for smoking, since scrap timber can carry glues or finishes. Assemble the parts on a heat-proof surface before you light anything. 

### Is a smoker gun better than a torch for a homemade smoker? 

A smoker gun gives you a steadier stream of smoke than a torch, because it burns the chips inside its own chamber and blows the smoke out through a tube. A torch is simpler and cheaper to set up, but it demands more attention to where the flame points. Both tools work with a homemade smoking board and a chamber over the glass. Whichever you use, the job needs care with heat near glass and wood.
