How to brew pour over coffee in a Chemex
A plain guide to brewing pour over coffee in a Chemex: the filter, the ratio, grind size, the bloom and how to pour for a clean cup.
Contents
Learning how to brew pour over coffee in a Chemex comes down to a thick filter, a steady pour and a ratio you can repeat. The Chemex brewer uses a bonded paper filter that traps fines and oils, which gives a bright, sediment-free cup. You control the grind size, the water and the pace of the pour, and each of those changes the result. This page walks through the setup, the pour and the adjustments that fix a brew that tastes wrong.
Set up the Chemex and filter
The Chemex filter is a heavy bonded paper square that folds into a cone with one side open for air. Rinse the folded filter under hot water before brewing, because the rinse heats the glass and washes papery taste out of the fiber. Set the filter so the multi-layer side faces the spout, then add coffee and level the bed. Place the brewer on a scale and keep the whole setup on a stable surface.
Pick a ratio and grind size
A pour-over ratio for the Chemex gives you a starting point, and a weight-based one works better than a scoop. Weigh the coffee and the water so the same numbers can be repeated, then change one of them at a time. Grind size for a Chemex sits coarser than for a cone dripper, because the thick filter slows the flow already. If the brew stalls, move the grind coarser; if it drains fast and tastes thin, move it finer.
Pour the bloom and the rest
The bloom is a first small pour that wets the grounds and lets trapped gas escape. Pour about twice the coffee weight in water, wait for the bed to settle, then continue in gentle circles. Keep the water level below the rim of the filter and pour from the center outward without touching the paper. Brew time depends on grind, dose and pour speed, so judge the finish by taste rather than a clock.
Questions About Chemex Pour Over Brewing
How do I brew pour over coffee in a Chemex?
Brewing pour over coffee in a Chemex means rinsing the filter, adding ground coffee, blooming it with a little hot water, then pouring the rest in slow circles. The thick filter and the glass carafe do most of the clarifying work. Weigh your coffee and water so the result can be repeated. Adjust grind size before you change anything else.
What ratio should I use for a Chemex pour over?
A pour-over ratio for a Chemex is a starting number you then tune to taste, and weighing both coffee and water keeps it honest. A stronger ratio suits a mug you drink slowly, while a lighter one keeps a large carafe from turning bitter. Change the ratio in small steps and note what you did. The Chemex filter holds back oils, so a slightly stronger mix can still taste clean.
What grind size works in a Chemex?
Grind size for a Chemex should be medium to coarse, closer to sea salt than to flour. The bonded filter slows water down, so a fine grind can stall the bed and leave a muddy taste. If the water sits on top too long, grind coarser on the next brew. A medium-coarse setting lets the Chemex drain evenly through the cone.
Does the bloom matter when brewing with a Chemex?
Yes, the bloom matters because fresh grounds release gas that can block water from reaching the coffee evenly. Wetting the bed with a small first pour lets that gas escape before the main pour. Wait until the surface stops bubbling, then continue in circles. Skipping the bloom in a Chemex tends to give a flatter, less even extraction.