ZERO PROOF. FULL OCCASION.

How much CO2 is in a cartridge and how many shots it gives

Learn how much CO2 a soda maker cartridge holds, why its real yield in carbonation shots varies, and how to plan fizz for a gathering without waste.

7 min read0 viewsHow much CO2 is in a cartridge and how many shots it gives
— · 0 votes
Contents
  1. What a soda maker cartridge actually contains
  2. The math from grams to carbonation shots
  3. Why bottle volumes and fizz level change the yield
  4. Estimating shots for your gathering
  5. What shortens a cartridge's yield
  6. Handling cartridges safely at a party
  7. Buying and storing cartridges for repeat hosting
  8. Questions About CO2 Cartridges and Shots
  9. How much CO2 is in a CO2 cartridge?
  10. How many shots from a CO2 cartridge?
  11. Does cold water give more shots per cartridge?
  12. Can I refill a CO2 cartridge myself?
  13. Why does my cartridge seem to run out early?
  14. How many cartridges do I need for a party?

A standard soda maker cartridge holds roughly 60 grams of CO2, which works out to about 30 liters of carbonated water at moderate fizz. The number of shots a cartridge gives depends on how much gas each bottle takes, so a gentle fizz stretches the charge further. You can plan a gathering by matching your target bottle volumes to the CO2 per charge you actually use.

  • A standard cartridge carries about 60 grams of CO2.
  • Each gram carbonates roughly half a liter of water at moderate fizz.
  • A cartridge gives around 30 shots if each bottle uses about 2 grams.
  • A heavy fizz bottle can halve the number of shots from one cartridge.
  • Chilling water before carbonating helps the gas dissolve and reduces waste.

What a soda maker cartridge actually contains

A soda maker cartridge is a small steel cylinder filled with liquid CO2 under pressure. The standard size used by home soda makers holds about 60 grams of CO2, measured as grams of CO2 rather than as volume. The liquid turns to gas as you release it into the bottle.

Cartridge sizes vary between brands and systems, and larger cylinders hold proportionally more gas. The 60 gram figure is the reference point for the small screw-in cartridges many home machines use. Always check the label on your own cartridge, because a different size changes every calculation.

The cartridge is sealed until it is pierced or screwed into the machine, and it cannot be refilled at home. CO2 per charge is fixed at the moment you connect it. Treat the cartridge as a single-use pressure vessel and never heat it or try to open it.

The math from grams to carbonation shots

Carbonation shots depend on how many grams of CO2 each bottle receives, so the total yield is a division. At a moderate fizz, a liter of water takes roughly 2 grams of CO2, which means a 60 gram cartridge gives about 30 liters. A typical bottle of about half a liter therefore gets around 30 shots from one cartridge.

Bottle volumes vary, and a liter bottle at the same fizz uses one charge of about 2 grams. If you carbonate a full liter in one go, you get fewer bottles but more water per shot. Count your bottles and their sizes before deciding how many cartridges to buy.

The figures above assume a moderate level of carbonation that stays lively for a while after pouring. A lighter fizz uses less gas and stretches the cartridge. A heavier fizz uses more and brings the shot count down.

Why bottle volumes and fizz level change the yield

Carbonation shots are not a fixed property of the cartridge, because each bottle takes what you give it. Bottle volumes set the floor: a bigger bottle needs more gas to reach the same fizz. Fizz level sets the ceiling: pushing toward heavy carbonation adds gas quickly.

Water temperature changes the result more than many drink makers expect. Cold water holds dissolved CO2 more readily, so it needs less gas for the same sparkle. Warm water pushes gas back out, and you may press the button longer to compensate.

Headspace inside the bottle matters too. A bottle filled past the marked line leaves no room for gas to pressurize, and a bottle filled well short wastes a charge on empty space. Follow the fill line on your bottle for a consistent cartridge yield.

  • Standard cartridge: about 60 grams of CO2
  • Moderate fizz: about 2 grams per liter
  • Half-liter bottle: about 1 gram per bottle
  • Liter bottle: about 2 grams per bottle
  • Gentle fizz: less gas per bottle
  • Heavy fizz: more gas per bottle

Estimating shots for your gathering

Plan cartridge yield by counting the bottles you expect to carbonate, not the glasses you expect to pour. Guests drink carbonated water at different rates, and a bottle opened and left standing goes flat. Estimate one bottle per two guests per round as a working starting point, then adjust.

Divide your planned CO2 per charge into the cartridge content to get a rough count. If you expect 40 half-liter bottles at moderate fizz, one cartridge will not cover it and a second is needed. Keeping a spare cartridge avoids a flat middle to the evening.

Chilled bottles and a clean machine reduce waste between charges. Carbonate in batches close to serving time so the fizz is at its peak when glasses are filled. The same logic applies to flavored sodas, where syrup is added after carbonation.

What shortens a cartridge's yield

A cartridge gives fewer shots when you over-carbonate, because excess gas vents from the bottle. Pressing the button beyond the recommended burst releases CO2 that you paid for. Follow the machine's stated number of presses for your fizz level.

Leaks at the connection waste gas before it reaches the water. A worn seal or a cartridge not fully seated lets CO2 escape during carbonation. Check the seal and the fit whenever a cartridge seems to empty faster than expected.

Carbonating warm water and carbonating bottles filled past the line both reduce cartridge yield. Both habits push you to use more gas for the same result. Changing either habit is free and protects the charge.

Handling cartridges safely at a party

A CO2 cartridge stores a large amount of pressure in a small steel shell, so treat it as pressure equipment. Keep cartridges away from heat, flames and direct sun. Never pierce, drill or open a cartridge by hand, because the release is violent.

Store cartridges upright and out of reach of children, and connect them only to the machine they are made for. A cartridge that is damaged, corroded or the wrong size for the machine should not be used. Replace it rather than forcing a fit.

Dispose of spent cartridges through the recycling route your supplier or local waste service offers for metal pressure vessels. Do not put a full cartridge in household waste. If you are unsure whether a cartridge is empty, ask the supplier rather than testing it.

Buying and storing cartridges for repeat hosting

Cartridge yield depends on your habits more than on the label, so buy for the pattern you actually carbonate. Hosts who serve sparkle at every gathering do well with a spare cartridge on hand. Those who carbonate occasionally can judge by the season.

Store unopened cartridges in a dry, cool place and keep them in their original packaging until use. Moisture and salt accelerate corrosion on the steel. A corroded cartridge is a reason to discard it, not to clean it and use it anyway.

Track how many bottles each cartridge carbonates so your estimate improves over time. A simple tally on the machine or in a note keeps the count honest. The tally converts grams of CO2 into a number you can plan around.

Questions About CO2 Cartridges and Shots

How much CO2 is in a CO2 cartridge?

A standard home soda maker cartridge holds about 60 grams of CO2. Larger cylinders hold proportionally more, and small cartridges hold less, so check the label on your own. The gas is stored as a liquid under pressure and released as needed.

How many shots from a CO2 cartridge?

A 60 gram cartridge gives roughly 30 shots if each half-liter bottle takes about 1 gram of CO2 at a moderate fizz. Heavier carbonation or larger bottles reduce that count. Treat the number as an estimate and adjust for your bottle volumes and fizz level.

Does cold water give more shots per cartridge?

Yes, cold water absorbs CO2 more readily and needs less gas for the same sparkle. Using chilled water therefore stretches the CO2 per charge in a cartridge. Warm water drives gas out of solution and can make you press the button longer.

Can I refill a CO2 cartridge myself?

No, home refilling of a soda maker cartridge is not a safe or supported practice. The cylinder is a pressure vessel rated for a single charge, and opening or refilling it risks a violent release. Exchange or replace the cartridge through the supplier instead.

Why does my cartridge seem to run out early?

A cartridge can run out early through leaks at the connection, over-carbonation that vents gas, or carbonating warm water. Bottles filled past the line also waste gas on headspace. Check the seal and your fill level before blaming the cartridge.

How many cartridges do I need for a party?

Divide your expected bottles by the shots your cartridge gives at your fizz level, then add a spare. A party pouring 40 half-liter bottles at moderate fizz needs more than one 60 gram cartridge. The exact number depends on bottle volumes and how heavy your carbonation is.

Read next

Latest articles