# Force carbonating in a keg: method and steps

How force carbonation works in a keg, from chilling the beer and setting CO2 pressure to shaking, resting at serving pressure, and pouring a clean glass.

Force carbonating in a keg means chilling the beer and pushing carbon dioxide into it under pressure until the beer holds the sparkle you want. The carbonation method steps depend on temperature, CO2 pressure and time, so the same regulator setting gives different results in a cold keg and a warm one. This page walks through a homebrew keg carbonation setup, from the CO2 regulator to the beer line at the tap. 

## How pressure and temperature drive carbonation 

Carbon dioxide dissolves into beer faster when the beer is cold and the pressure above it is high. A CO2 pressure chart links temperature and keg pressure to a target level of dissolved gas, so you set one against the other. Warm beer holds less gas at the same regulator reading, and the gas enters it slowly. Chill the keg first, then set the CO2 regulator to the pressure your chart gives for that temperature. 

## The quick shake method, done carefully 

Shaking a chilled keg speeds the transfer of gas into the beer, and the pressure drops as gas dissolves. Set the CO2 regulator to a higher pressure than serving pressure, then rock the keg until the gas stops hissing into it. Turn the gas off and let the keg rest before you vent and test the pour. Shaking can overshoot the target, so check the beer instead of trusting the gauge alone. 

## Set and forget at serving pressure 

The set and forget approach connects the keg to CO2 at the pressure you want to serve at and leaves it to equalize. Gas dissolves over hours and days without shaking, and the beer settles at the carbonation the pressure chart predicts. Keep the keg cold the whole time so the balance holds. This method suits a keg you plan to pour over several evenings, because each pour stays consistent. 

## Force carbonation questions 

### Can I force carbonate beer at home without special equipment? 

Yes, homebrew force carbonation needs only a sealed keg, a CO2 cylinder, a regulator and a gas line with the right disconnect. A carbonation cap on a plastic bottle suits small test samples. The regulator is the part that makes the pressure repeatable, so borrow or buy one before you start. 

### How much CO2 pressure should I use for force carbonation? 

Force carbonation pressure depends on the beer temperature and the sparkle level you are aiming for. Cold beer needs less pressure than warm beer to hold the same gas, and a pressure chart gives the pair of readings. Set the CO2 regulator to the pressure for your keg temperature rather than picking a number by feel. 

### What is Kegland force carbonation equipment? 

Kegland makes kegs, regulators, carbonation caps and gas fittings used for force carbonating beer. The brand name tells you the fittings and thread sizes you may meet, not a separate carbonation method. Force carbonation still follows the same balance of CO2 pressure, temperature and time. 

### Why is my force carbonated beer foamy at the tap? 

Foam at the tap often means the keg pressure is too high for the beer line length or the beer is warmer than the chart assumes. A longer or narrower beer line adds resistance and calms the pour. Vent the keg, check the serving pressure and temperature, then pour again after the line has chilled.
