Fixing a leaking blender: causes and repairs
Find why your blender leaks from the bottom or the lid, and learn how to fix a worn gasket, a loose jar base or a cracked jar before your next round of drinks.
Contents
Fixing a leaking blender starts with finding where the liquid escapes, because a leak at the bottom and a leak at the lid have different causes. A worn jar gasket, a loose or cross-threaded jar base, a damaged blade assembly seal or a cracked jar each produce their own kind of drip. This page explains how to trace the leak, which parts you can tighten or replace yourself and when the job needs a trained repair specialist.
Why a blender leaks from the bottom
Liquid that pools under the blender jar passes the blade assembly seal or the joint where the jar meets its base. The blade assembly seal is a rubber ring that sits between the blade unit and the jar, and it hardens or tears with age. A jar base that is not screwed on squarely leaves a gap on one side, so check the thread before you blame the rubber. Run the empty jar under water with the base fitted and watch for a bead forming at the seam.
Checking the gasket and jar base
A worn rubber gasket is the first part to inspect when a blender drips at the bottom, since rubber loses its squeeze over time. Lift the gasket out and look for flattening, small cracks or a stretched shape that no longer sits in its groove. Clean both the groove and the gasket, then reseat the gasket flat and screw the jar base on hand-tight. Fit the jar back on the motor base with the blender unplugged, and never force a base that resists the thread.
Lid seals, cracks and when to stop
A lid seal that is dry or gritted lets liquid creep up the sides during a fast blend, and overfilling the blender pushes liquid into the lid. A cracked blender jar cannot be repaired with glue, so retire that jar and fit a replacement before the next gathering. Model parts differ between a Smeg blender and a KitchenAid blender, so match the gasket and jar to your own model. Stop and seek a trained specialist if the motor housing or the wiring shows liquid inside, because water near electrical parts can hurt a person.
Questions about blender leaks
Why is my blender leaking?
A blender leaks because liquid finds a path past a seal, a loose joint or a crack in the jar. The worn rubber gasket at the blade assembly lets liquid through when it flattens or tears. A jar base that is loose or cross-threaded opens a gap on one side of the seam. A dry lid seal or an overfilled jar sends liquid up and over the top instead.
How do I fix a leaking blender?
Fixing a leaking blender means cleaning and reseating each seal first, then tightening the jar base by hand. Unplug the machine, empty the jar and remove the base to reach the gasket and blade assembly seal. Replace any rubber part that is cracked, stretched or no longer sits in its groove. Reassemble the base squarely and test with plain water before you blend anything else.
Why is my blender leaking from the bottom?
A leak from the bottom of a blender points to the blade assembly seal or the jar base joint. Liquid collects under the jar when the rubber ring has lost its grip or the base is not screwed on straight. A cracked jar around the base thread also lets liquid escape at the bottom. Inspect both parts with the blender unplugged and replace any that are damaged.
Where can I find a KitchenAid or Smeg blender leaking fix?
A leaking KitchenAid or Smeg blender needs the gasket and jar parts made for that exact model. The fix follows the same order as any blender, so clean the seal, reseat the gasket and tighten the jar base by hand. Order the replacement gasket or jar through the maker's parts service rather than a universal ring. A specialist can handle a leak that reaches the motor housing.