# Fixing a dispenser that is not dispensing

Trace a beverage dispenser that is not dispensing, from spout blockage and clogged spigot to air locks, valve failure and the power or battery check.

Fixing a dispenser that is not dispensing starts with finding where the flow stops, since the fault sits in the spout, the line, the valve or the power supply. You can check a beverage dispenser not working in a set order and rule out the simple causes before anyone opens the machine. A fountain soda dispenser not working often returns to a spout blockage or a clogged spigot, while a water dispenser not dispensing usually points to air in the line or a valve that fails to open. The checks below follow the drink from the reservoir to your glass. 

## Clear the spout and spigot first 

A spout blockage or a clogged spigot stops flow at the last point before the glass. Remove the spout or nozzle where the maker allows it, then rinse it and look through it against a light. Sticky syrup residue and mineral scale build up inside narrow openings and cut the stream to a drip. Soak the part in warm water and a mild cleaner, and never poke a wire into a dispensing opening that carries electricity. 

## Chase air out of the line 

An air lock in the dispenser holds a pocket of gas that blocks the liquid behind it. This happens after a bag or tank runs dry, after a line is reconnected, or after the machine sits unused. Purge the line at the tap until a steady stream runs without spitting. A pump or valve failure can mimic an air lock, so listen for the pump and watch whether the valve clicks when you call for a drink. 

## Check power, battery and valve 

A power and battery check comes before any work on the wet side of the machine. Confirm the plug, the switch and any battery backup, because a dispenser with no current cannot open its valve. Soda dispenser troubleshooting then moves to the solenoid valve, which opens on a signal and closes on a spring. Where the valve or the pump needs replacement, a trained service technician should do the job. 

## Questions on dispenser flow problems 

### Why is my beverage dispenser not dispensing anything at all? 

A beverage dispenser that dispenses nothing at all has lost either its power or its supply. Check the plug, the switch and the battery backup first, then confirm that syrup or water reaches the machine. If the machine has current but no sound comes from the valve, the fault sits in the valve circuit. 

### What causes a beverage dispenser spout to stop working? 

A beverage dispenser spout stops working when residue, scale or a small piece of debris blocks the opening. Syrup left to dry inside the nozzle hardens and narrows the passage. Remove the spout where the maker allows, soak it in warm water and rinse it before you refit it. 

### How do I fix a soda dispenser that is not working? 

Soda dispenser troubleshooting begins with the syrup supply, the carbonation line and the valve. A soda dispenser not working often has an empty bag, a disconnected line or a valve that fails to open. Check the power and the pump sound before you touch any fitting that holds pressure. 

### Why is my water dispenser not dispensing water? 

A water dispenser not dispensing water may hold an air lock after a tank change, or its valve may fail to open. Purge the tap until the stream runs steady and without spitting. Mineral scale in the spout also restricts flow, so clean that part before you call a technician.
