# Cleaning a juicer screen and strainer mesh

How to clean a juicer screen and strainer mesh: soak the filter, clear pulp from small holes, and keep the mesh free of clogging between juicing sessions.

[Cleaning a juicer](/articles/how-to-clean-a-fruit-juicer-for-crystal-clear-clarified-drinks/) screen and strainer mesh comes down to soaking the filter soon after juicing, then lifting pulp out of the small holes before it dries hard. The screen holds the fine mesh that separates juice from fiber, so residue left in it blocks flow and flavors the next batch. A short soak, a soft brush and a warm rinse keep the mesh open without bending the wire. 

## Why the mesh filter clogs 

A juicer mesh filter clogs because fine fiber packs into the weave while wet and sets firm as it dries. Pulp clogging builds fastest at the center of the screen, where the spinning basket presses material against the metal. Once the weave is blocked, juice backs up and the machine works harder for less yield. Rinsing the screen before the fiber dries saves far more effort than scraping a hardened layer later. 

## Soaking the screen first 

Soaking the screen loosens dried fiber so it lifts away instead of tearing at the mesh. Fill a basin with warm water and a little dish soap, then lay the screen flat with the mesh facing down. Leave it long enough for the pulp to soften, which depends on how dry the residue has become. A soft sponge or cloth wipes the softened fiber away without pressing it deeper into the holes. 

## Cleaning tools for small holes 

Cleaning tools for small holes should be soft, thin and blunt so they push pulp out without bending wire. A small brush with stiff nylon bristles works along the weave, and a wooden pick clears the tightest spots. Never use a knife tip, a metal skewer or an abrasive pad on a fine strainer mesh. Hold the screen up to a light afterward, because any dark spot left in the weave is pulp that will block the next batch. 

## Questions About Juicer Screen Cleaning 

### How do I clean a juicer screen without damaging the mesh? 

You clean a juicer screen by soaking it in warm soapy water and wiping it with a soft brush or cloth. Pressing hard or using metal tools bends the fine wire and widens the holes. Rinse from the back of the mesh so pulp pushes out the way it came in. Dishwasher cleaning suits only screens the manufacturer lists as dishwasher safe. 

### Should I soak the screen before scrubbing it? 

Yes, soaking the screen first makes scrubbing far easier and gentler on the mesh. Dried pulp softens in warm water, so it lifts away instead of resisting the brush. The soak time depends on how long the residue has been sitting and how thick the layer is. A short soak right after juicing is enough for fresh fiber. 

### What causes pulp clogging in the strainer mesh? 

Pulp clogging happens when fine fiber packs into the weave and is left to dry there. Wet pulp presses into the holes during juicing, and heat from the machine sets it harder. Rinsing the screen promptly keeps most fiber from settling into the mesh. A screen that stays partly blocked reduces juice flow on every later batch. 

### Which cleaning tools work for the small holes in a juicer screen? 

A soft nylon brush and a blunt wooden pick are the tools that work for small holes in a juicer screen. Both loosen fiber without scratching the metal or bending the wire. An old toothbrush reaches the curved edge where pulp collects. Metal skewers and abrasive pads can damage the mesh, so keep them away from the screen.
