ZERO PROOF. FULL OCCASION.

Bartender measurement terms

Learn bartender measurement terms, from the jigger and the pony shot to the dash, and see how bar units, pour terms and glassware capacity fit together.

3 min read14 viewsBartender measurement terms
— · 0 votes
Contents
  1. Jiggers, ponies and pour measures
  2. Dashes, drops and small units
  3. Glassware capacity and fill level
  4. Questions about bar measurement terms
  5. What is a jigger in bartending?
  6. How much is a dash?
  7. What is a pony shot compared with a shot?
  8. Do millilitres and ounces both appear in bar recipes?

Bartender measurement terms are the words a bar uses to name a quantity of liquid, and each term carries a size or a role behind it. A jigger measures a set pour, a dash adds a small seasoning, and glassware capacity tells you how much the finished drink should fill. Knowing these bar measures and pour terms helps you follow a recipe and repeat a drink you liked. The notes below explain the units, the tools and the glassware side in plain words.

Jiggers, ponies and pour measures

A jigger is the double-ended measuring tool a bartender holds over the glass, with a larger cup on one side and a smaller cup on the other. The jigger names the tool and, loosely, the pour it gives, while a pour measure is the general term for any fixed amount a bar pours. A pony shot is a small pour measure that sits below a full shot, so a recipe can call for a pony and mean a short measure. These bar units let one drink be scaled up or down without guessing at the strength.

Dashes, drops and small units

A dash is a tiny pour used for bitters and strong flavorings, shaken from a bottle rather than measured in a cup. The dash has no fixed size across all bars, so the bottle, the dash size and the wrist all change how much lands in the drink. A drop is smaller still and appears in recipes for intense ingredients such as aromatic extracts or saline. Treat these bartending terms as a guide to balance and taste the drink as you build it.

Glassware capacity and fill level

Glassware capacity is the total volume a glass holds when full to the rim, and it differs from the pour a recipe gives. A drink built with ice, dilution and garnish needs room in the glass, so the recipe pour sits below the capacity. Bartenders check capacity in a millilitre or ounce figure and then choose a glass that leaves headroom. Matching pour measures to glassware capacity keeps a serve from overflowing when the ice melts.

Questions about bar measurement terms

What is a jigger in bartending?

A jigger is a double-ended measuring tool for spirits and mixers, with a large cup and a small cup. Bartenders use a jigger to pour an exact measure instead of guessing, and the word also describes the pour itself. Owning one jigger lets you measure most standard recipes, because the two cups cover the amounts drinks call for.

How much is a dash?

A dash has no single fixed size, because the bottle, the dash restrictor and the bartender's hand all change the volume. Recipes use a dash for bitters and other intense flavorings where a small amount shifts the balance. Start with one dash, taste, and add another if the drink needs it rather than pouring a measured spoon.

What is a pony shot compared with a shot?

A pony shot is a small pour measure that sits below a standard shot in size. Bars use the pony shot for a short serve or a recipe that wants less spirit in the mix. If a recipe names a pony, check the ounce or millilitre figure your bar uses, since the exact size can vary.

Do millilitres and ounces both appear in bar recipes?

Millilitres and ounces both appear in bar recipes, and a bartender converts between them to follow a source from another region. The millilitre is a metric unit and the ounce is an imperial unit, and each recipe tends to keep one system throughout. Choose one system for your own notes so a drink stays consistent when you scale it.

Read next

Latest articles